Brake Bleeder Hose 2 Pack – One Man Brake Bleeder Kit, 45cm

Two brake bleeder hoses with a built-in one-way check valve, so one person can bleed the brakes on a car or motorbike without a helper on the pedal.

Push the short end of the clear hose over the bleed nipple, run the long end into a catch bottle, open the nipple a quarter turn and pump the brake pedal or lever. Old fluid and air bubbles flow out through the valve, but the valve stops air being drawn back in on the return stroke. Watch the clear hose until the fluid runs bubble-free, then close the nipple. Each hose is about 45cm long overall with an 8mm tube and spring hose clips, and you get two so you can bleed one wheel while the other is on standby.

What You Get

Specifications

Bleeding tip: start at the wheel furthest from the master cylinder and work towards the nearest, and keep the reservoir topped up with the correct fluid so it never runs dry.

Why Buy This Brake Bleeder Kit

• One-person job - the check valve does the work of a second person
• Clear hose - see the bubbles stop
• Two hoses - spare for the next job or a second vehicle
• Cars and motorbikes - fits most bleed nipples
• Simple and reusable - no pumps or power needed

Care & Use

Flush the hose with fresh brake fluid or clean it after use, and store it capped and dry. Catch old fluid in a container and dispose of it responsibly. Brake fluid damages paint, so wipe up spills straight away. If you are unsure about brake work, have a qualified mechanic check the system before driving.

Please allow a small measurement tolerance due to manual measurement, and slight colour variation due to different monitor settings.

Where It Gets Used

Home garages and driveways, for brake fluid changes and bleeding after replacing pads, lines or calipers on cars, utes and 4WDs.

Motorbike riders use them on hydraulic disc brakes and clutches, and small workshops keep a few in the toolbox.

Frequently Asked Questions

How does the one-way valve work?
Fluid and air can flow out of the bleed nipple through the valve, but air cannot be drawn back in when you release the pedal.

Will it fit my bleed nipple?
The soft clear hose pushes over most car and motorbike bleed nipples. Check the 8mm hose against your nipple size.

Do I still need a catch bottle?
Yes. Run the long end into a bottle or container to catch the old fluid.

How long are the hoses?
About 45cm overall.

How many are included?
Two.

Free Delivery

GST is included in every price. Free delivery Australia-wide. Express Post is available at extra cost. PO Boxes and parcel lockers OK.

This is a generic brake bleeding tool and is not associated with any vehicle brand. Brakes are safety-critical: test the brakes before driving, and see a qualified mechanic if in doubt.